![]() For this reason, I have several compilation errors like the following: Therefore, all references to affected table classes became invalid. Since, I have recently disabled Pluralization of names, after regerating some database related classes, some of them lost their " s" prefix. In my case, I have noted that some old pluralized (*) table names (upon which SQLMETAL adds, by default, an " s" letter at the end) table references to classes generated by SQLMETAL. If so, you may be facing a pluralized to unpluralized transition issue. If this is the cause, then adjust the build order.Īre you using a database code generation tool like SQLMETAL in your project? If the path contains space or any other invalid path character, remove it and try building again. This might be the cause for the error.Ĭheck the path of the missing. Check the project dependencies and the build order to verify if some project (say 'project1') which is dependent on other (say 'project2') is trying to build before that one (project2). This build order is the one in which solution builds. You will see 2 tabs: 'Dependencies' and 'Build Order'. If the above solution(s) do not work, then follow sequence mentioned in step 2 above, and even if all the checkboxes are checked, uncheck them, check again and try to build again. ![]() If any or all of them are unchecked, then check them and try building again. Check if the checkboxes under 'Build' are checked or not. For that, I read many posts, blogs etc and found these solutions may be effective (summarizing them over here): I tried to get rid of ‘metadata file could not be found’ error. I had 4 errors of this kind (‘metadata file could not be found’) along with 1 error saying 'Source File Could Not Be Opened (‘Unspecified error ‘)'. Well, my answer is not just the summary of all the solutions, but it offers more than that. However, when you do have them like this, it's a real pain in trying to find out what's going on. I don't know why it happens and it's somewhat rare for me to have these issues. I've seen this in the past where after fixing issues, subsequent compiles show NEW errors. Sometimes, it seems, when compiling, that the compiler will exit on some errors. NOTHING seemed to work, until I found these errors which did not show up when compiling the entire solution!!!! I fooled around with build orders, no build orders, referencing debug dlls (which were manually compiled). But in my case, I didn't see any of the other compiler errors!!! I kept working at trying to compile each solution manually, and only after getting VS2012 to actually reveal some compiler errors I hadn't seen previously, this problem vanished. When this message is shown it can have the meaning of "one or more projects in your solution did not compile cleanly" thus the metadata for the file was never written. I had this problem for days! I tried all the stuff above, but the problem kept coming back. Project(""Ĭheck again Foldernames (I have highlighted in BOLD) and make it similar to what you did in step 2.īuild The Solution (If doesn't work try building individual after cleaning again) In your initial lines you would find for lines for every project like below:
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |